Filter
Top Products
INSTALLATION
Modular Jack
PULSE/TONE Switch
Telephone Line Cord
Power Cord
FOR TABLE/DESK INSTALLATION
1 Choose a spot near an electrical outlet and a
telephone jack. This phone requires a modular
telephone jack and a standard electrical outlet (110v AC).
2 Install the handset battery.
For an illustration of battery installation, see BATTERIES.
• Plug the battery pack connector into thehandset
and place the battery pack into the case, so the
wires rest between the battery pack and the case.
• Place the battery case cover on the handset by
sliding it on its track up over the battery case
until it snaps firmly in place.
3 Install the handset antenna.
Screw the antenna into the opening at the top of the handset.
4 Connect the telephone line cord.
Plug one end of the telephone line cord into the jack
on the back of the base. Plug the other end of the
line cord into a modular phone jack. Make sure the
plug snaps firmly in place.
5 Connect the power cord.
Plug the power cord into the POWER jack on the
back of the base. Plug the AC adapter on the power
cord into an electrical outlet.
6 Charge the handset batteries for 10 hours before use.
Place the handset face up or face down in the base if
your phone is installed on a table. Place the handset
face down in the base if your phone is installed on a
wall. (The handset charges only face-down when the
base is wall-mounted.) The CHARGING light on the
base goes on to show the handset is in the right position
to charge the batteries.
7 Check for dial tone.
After the batteries are charged, pick up the handset and
make sure the base antenna is upright. Check for dial
tone by pressing P; the PHONE light should go
on and you should hear a dial tone.
8 Set the dial mode.
If you have touch tone service, the phone will be
ready to use as soon as the battery is charged.
NOTE: If you have dial pulse service, you’ll need to
set the dial mode. Set the PULSE/TONE switch on
the back of the base to PULSE.
CAUTION: Use only the AC power adapter supplied
with this telephone. Power Supply 4000T. Input: AC 120v,
600 Hz, 4.7W Output: 120 VDC, 200 mA.
AC Adapter
1