Filter
Top Products
INSTALLATION
1
RING SELECT
Telephone Line Cord
MSG ALERT
POWER
Battery Installation (optional)
2 Connect the line cord to the telephone.
Plug one end of the line cord into the jack labeled TEL
LINE on the bottom of the telephone. Run the line
cord through the channel on the bottom of the phone.
3 Connect the handset to the telephone.
Plug the coiled cord into the handset jack on the side
of the phone. Plug the other end of the coiled cord
into the handset, then hang up.
4 Connect the line cord to a wall jack.
Plug the free end of the line cord into a telephone wall
jack. Make sure the cord snaps firmly into place.
5 Connect the power cord.
Fit the power cord behind the strain relief tab. Then,
plug the smaller end of the power cord into the jack
labeled POWER on the back of the system. Plug the
power cord into an electrical outlet not controlled by
a wall switch. (When you connect the system to
power, the Message Window flashes CL to indicate you
need to set the clock. See “Setting the Clock” in the
ANSWERING SYSTEM OPERATION section of this
manual.)
ANNC SELECT
For Table/Desk Installation
1 Install the batteries.
• Turn the unit upside down.
• Push in on the two tabs at the large end of the
base, and lift the base off the unit.
• Push in on the two tabs on the battery
compartment door, and remove it.
• Insert four AA batteries. Always use four new
batteries.
• Replace the battery compartment door.
• Reattach the base by inserting the tabs into the
slots. Push down on the large end of the base to
lock it into place. Make sure the larger end is
toward the top of the telephone. The telephone
should sit flat on your table or desk during use.
NOTE: The batteries provide backup power, allowing
you to make calls in case of a power failure. When
battery power is low, the LOW BATTERY light goes on.
Replace the batteries promptly.