Filter
Top Products
Memory Full
If the system answers after 10 rings and beeps twice
instead of playing your announcement, the system is off,
memory is full, or the AO announcement is selected but
not recorded.
1 Enter your Remote Access Code after the 2-beep signal.
2 Listen to messages, and delete some or all of them.
3 Press 7, 1 to check your announcement. If you hear
no announcement, press 7, * to record a new
announcement.
4 Press 0 to make sure your system is on before you
hang up.
Voice Help Menu
The Voice Help Menu allows you to use several system
features from a remote location even when you cannot
remember the touch tone commands. All you need to
know is your Remote Access Code, and the system will
prompt you. As soon as you hear the command you need,
press the appropriate buttons.
REMOTE OPERATION
Changing Your Remote Access Code
1 Connect with the answering system.
2 Press and release 9, 9. The system announces “Enter
new code.”
3 Enter your new Remote Access Code (any number
between 500 and 999 except for the Priority Calling
Code).
4 If a valid code is entered, the system announces the
new Remote Access Code. If an invalid code is
entered, the system beeps five times rapidly, then
beeps twice. Repeat Steps 2 and 3.
Turn System Off
1 Connect with the answering system.
2 Press 8, 8, then hang up.
Turn System On
When the system is off, it answers after 10 rings and beeps
twice.
1 Press 0 to turn the system on.
2 The system beeps twice and is ready to answer calls
and record messages. If the system beeps five times,
the memory is full.
11