Filter
Top Products
5
Redial
The telephone always stores in memory the last number
dialed. To dial the same number again, lift the handset, and
press .
The redial memory can accept numbers up to 32 digits long.
The number will remain in memory until you change it by
dialing another telephone number.
For privacy, you can erase the redial memory. Lift the
handset, then press any digit (1-9).
Flash
Press instead of pressing the switchhook to activate
customer calling services such as call waiting or three-way
calling. You may have to press other buttons before or after
as explained in custom calling instructions provided
by your local telephone company.
Ringer Volume
The RINGER volume switch allows you to adjust the loud-
ness of the telephone ringer from OFF to LO to HI. Slide
the switch to the desired volume level.
Receiver (Handset) Volume
The Receiver volume switch on the left side of the base has
three positions which allow you to adjust the loudness of
your call from NORMAL to LOUD. Slide the switch to the
desired volume level.
Temporary Tone
Temporary tone dialing is used only when you have rotary
service. It allows you access to services that require tone
signaling, including some tone-activated computer systems
(e.g., telephone banking).
To change from pulse (rotary) to tone dialing during a call:
1. Dial a telephone number with the dial mode switch set to
PULSE.
2. Press ; all buttons pressed after this will send
tone signals.
3. After you hang up, the phone automatically returns to
rotary service.
TONE
FLASH
FLASH
REDIAL
OPERATION