Filter
Top Products
TABLE/DESK INSTALLATION
This telephone includes a 7-foot line cord with a modular
plug on each end. You’ll use this cord to connect the
telephone to a modular jack.
1. Connect line cord to telephone
Plug the long line cord into the jack on the underside of
the telephone base. Then feed the line cord through the
channel provided so the telephone sits flat on your table
or desk during use.
2. Set Dial Mode switch
This product comes set in the TONE mode. Make sure
you choose the correct dialing method (TONE/PULSE);
touch tone dialing will not work if you have dial pulse
service.
3. Connect handset to base
Plug one end of the coiled cord into the handset, and
the other end into the telephone base. Then hang up.
4. Connect line cord to modular jack
Plug the free end of the line cord into a modular jack.
Make sure it snaps firmly in place.
5. Check for dial tone
Lift the handset and listen for a dial tone. If you can’t
hear a dial tone, refer to “In Case of Difficulty” and try
to correct the problem.
TO DISCONNECT the telephone, squeeze the clip on
the modular plug and pull it out of the jack.
2
INSTALLATION