Filter
Top Products
IPF-2600 User’s Manual/
17
IPF2600 can support 2 Lines, user can switch to another line for making or answering calls and
automatically put an ACTIVE call on Hold.
When receiving second incoming calls, besides playing a stutter Call Waiting tone,IPF2600 will pick up
the next corresponding available LINE.
IPF2600 supports both BLIND and ATTENDED Transfer:
1. Blind Transfer: When in conversation with an “ACTIVE” LINE If there is no LINE on HOLD, user press
“Hold” button, hold current Line call, Then press “XFER” button Input target number, this will directly
transfer the holden party in the corresponding LINE to the dialed number.
2. Attended Transfer: When a LINE is “ACTIVE”, user will get a dial tone by pressing the “XFER” button, then
dial the number and then press the “#” button, user could talk with the Line and then hang up, the Holden Line
will connect with the current Line.
Note:
Transferring calls across SIP domains need to be supported by SIP services.
IPF2600 supports 3-way conference. With one LINE ACTIVE and another LINE on HOLD, press
the CONF button then the LINE that is on HOLD will join the three parties together in a conference.
If after pressing the “CONF” button, a user (not Holder) decides not to conference anytime, user can
cancel it and resume the conversation by pressing “Hold” or the original LINE button.
If the conference holder wishes to end a conference, simply Hook Off or press “Speaker” button, the
conference Holder could not to hold /resume the conference, if the conference holder hang up, the other user
could continuous talk with each other, which breaks the conference and places both parties, user can then talk
to each individual party.
When in conversation with an ACTIVE LINE, pressing “MUTE”
MUTE
will mute the conversation,
that is, you can hear the other party but the other party cannot hear you. Pressing the button again will resume
the conversation.
There are 10(M1-M4 and “0”,”5-9”) speed dial buttons, each can be configured with a different account
to dial.
Press M1-M4 will directly dial the preset calling party number at Speakerphone mode
Pick up handset or Press “Speaker” button, Press “0-9” followed by “#” to call the preset calling party
number.
Note:
M1-M4 Support PSTN Speed Dial if No PSTN Active/Hold (Default PSTN).
“0-9” only Support IP/SIP Speed Dial.