Filter
Top Products
IPF-2002L User Manual
13
5.1.2 Static IP Setting
Please input the Static IP comes from your ISP, or the Private IP address, Subnet Mask, and
Default Gateway IP address in your company.
1. Connect the RJ-45 Ethernet Cable to the LAN port on the IPF-2002L, and then plug in the
power.
2. Press 1234# (Hold the “#” key) Æ LCD shows【password】Æ Press 1234 and then press
ENTER Æ LCD shows【network settings】.
3. Press ENTER Æ LCD shows【iptype】Æ press SPD/HOLD Æ Blinking cursorÆ Press 0
and then press ENTER. (0 sets your networking settings to the Static IP mode)
4. Press ENTER Æ LCD shows【ip】Æ Press SPD/HOLD Æ Blinking cursor Æ Input IP
address (XXX*XXX*XXX*XXX) and then press ENTER.
5. Press ENTER Æ LCD shows 【subnet mask】Æ Press SPD/HOLD Æ Blinking cursor Æ
Input Subnet Mask information (XXX*XXX*XXX*XXX) and then press ENTER.
6. Press ENTER Æ LCD shows【router】Æ Press
SPD/HOLD Æ Blinking cursor Æ Input
default gateway information (XXX*XXX*XXX*XXX, where X is any number or character)
and then press ENTER.
5.1.3 DHCP Setting
1. Connect the RJ-45 cable to the LAN port on the IPF-2002L, and then plug in the power.
2. Press 1234# (Hold the # key) Æ LCD shows 【password】Æ Press 1234 and then press
ENTER Æ LCD shows【network settings】.
3. Press ENTER Æ LCD shows【iptype】Æ Press SPD/HOLD Æ Blinking cursor Æ Press 1
and then press ENTER (1 sets your networking settings to the DHCP mode).
5.2 Protocol Settings
1. Press 1234# (Hold the “#” key) Æ LCD shows【password】Æ Press 1234 and then press
ENTER Æ LCD shows【network settings】 Æ Press VOL - Æ LCD shows【protocol
settings】.
2. Configure if IPF-2002L needs to login to the server.
【protocol settings】Æ Press ENTER several times Æ LCD shows【service】.
• If the IPF-2002L is not going to register on the server, press SPD/HOLD Æ Press 0 (Not
register to the server) and then press ENTER.
• If the IPF-2002L is going to register on the server, press SPD/HOLD Æ Press 1
(Register to the server) and then press ENTER.
3. Configure the server IP address on the IPF-2002L:
【protocol settings】Æ Press ENTER several times Æ LCD shows【service address】Æ
press SPD/HOLD Æ Input server IP address (XXX*XXX*XXX*XXX, where X is any number
or character) and then press ENTER.