Filter
Top Products
IPF-2002L User Manual
14
4. Enable the STUN service to penetrate the NAT network when using SIP protocol.
【protocol settings】Æ Press ENTER several times Æ LCD shows【nat traversal】Æ
Press SPD/HOLDÆ Press 4 (Enable STUN) and then press ENTER Æ Press ENTER Æ
LCD shows【nat addr】Æ Input STUN server IP address (XXX*XXX*XXX*XXX, where X is
any number or character) and then press ENTER.
5. Configure the IPF-2002L register type
【protocol settings】Æ Press ENTER several times Æ Press VOL+ several timesÆ LCD
shows【local type】Æ Press SPD/HOLD.
• Press 0 (Input the phone number as E.164 to register to the server) and then press
ENTER.
• Press 1 (Input the account number) and then press ENTER. If this option is used,
please also configure step 7 and 8.
6. Configure IPF-2002L register account.
【 protocol settings 】 Æ Press ENTER several timesÆ LCD shows 【 account 】 Æ
Press SPD/HOLD Æ Input register account (XXX) and then press ENTER.
7. Configure IPF-2002L account password.
【protocol settings】Æ Press ENTER several timesÆ LCD shows【pin】Æ Press
SPD/HOLD Æ Input account password (XXX) and then press ENTER.
8. Configure IPF-2002L register port.
【protocol settings】Æ Press ENTER several timesÆ LCD shows【register port】Æ Press
SPD/HOLD Æ Input register port (XXX) and then press ENTER.
5.3 Audio Settings:
1. Press 1234# (Hold the “#” key) Æ LCD shows【password】Æ Press 1234 and then press
ENTER Æ LCD shows【network settings】Æ Press VOL – several times Æ LCD shows
【audio settings】.
2. Configure the codec type for IPF-2002L.
【audio settings】Æ Press ENTER Æ LCD shows【audio type】Æ Press SPD/HOLD.
• Press 0 (configure the codec as G.729) and then press ENTER.
• Press 1 (configure the codec as G.723.1) and then press ENTER.
• Press 2 (configure the codec as G.711u) and then press ENTER.
• Press 3 (configure the codec as G.711a1) and then press ENTER.
• Press 4 (configure the codec as auto) and then press ENTER.
3. Configure the volume of the phone handset and speaker.
【audio settings】Æ Press ENTER several times Æ LCD shows【 handset in】 Æ
Press SPD/HOLD Æ Input the volume of the phone handset and speaker (Default is 7,
Max is 15) and then press ENTER.