Aiphone JF Intercom System User Manual


 
Aiphone JF Series 13710 (28 13 00) - 5
Specifier Notes: Edit the system description as required for the project. Consult Aiphone Corporation
for more information.
A. Answering Door Call in Hands-Free Mode:
1. Press CALL button.
2. Chime tone sounds, caller is seen on video monitor, and outside sound is heard.
3. Audio and video turn off after approximately 45 seconds if not answered.
4. Press TALK button momentarily, and after beep, communicate hands-free. Red transmit
LED lights when you talk, and goes off as you listen to caller or hear outside sounds.
5. Press TALK button again, and after beep, communication ends.
B. Answering Door Call in Press-to-Talk (PTT) Mode:
1. Press CALL button.
2. Chime tone sounds, caller is seen on video monitor, and outside sound is heard.
3. Audio and video turn off after approximately 45 seconds if not answered.
4. During communication, press and hold TALK button for minimum of 1 second to change to
press-to-talk mode. Beep sounds, and after approximately 1 second another beep
sounds, PTT mode is entered. If TALK button is pressed less than 0.5 seconds,
communication ends.
5. To continue speaking using press-to-talk mode, press TALK button for minimum of 1
second each time to talk, and release to listen to caller.
6. Press TALK button again momentarily, and after beep, communication ends.
C. Activating Door Release:
1. During communication, instant voice call, or entrance monitoring, press MENU/MEMO
button to display menu screen.
2. Press CALL button.
3. Open door while release mechanism is activated. During activation of door release,
release symbol is displayed.
D. Message for Entrance:
1. During communication, instant voice call, or entrance monitoring, press MENU/MEMO
button to display menu screen.
2. Press PLAY button.
3. Press either CALL button or PLAY button. Selected message changes to yellow,
“SENDING MESSAGE” is displayed, and selected message is played from door station.
E. Entrance Monitoring:
1. Press MONITOR button in standby mode.
2. Video monitor displays image from door station 1 and incoming audio is heard. If you do
not press TALK button, caller will not hear sounds from inside station.
3. Press MONITOR button again to switch to door station 2. Each time MONITOR button is
pressed, unit switches in sequence “Standby” to “Door station 1 monitor” to “Door station 2
monitor” to “Standby”.
4. Press MONITOR button again to end.
F. Room-to-Room Communication:
1. Press CALL button to talk with other person.
2. Red CALL button flashes and “All Call” function is activated to link all master and sub
master stations.