Aiphone GT-2H-L Intercom System User Manual


 
- 17 -
3UUUUUU
6(1625$&7,9$7('
5(6(7
SECURITY
ABSENCE SECURITY
PRESENCE SECURITY
[ S1 S2 S3 ]
:ON :ALARM ACTIVATED
START
SECURITY
SENSOR2 [ ENABLE ]
SELECT SENSOR TO BE ON ALART.
SENSOR1 [ ENEBLE ]
SENSOR3 [ DISABLE ]
External calls9-3
1 When a separately-installed sensor is activated or the CALL button is
pressed, the alarm sounds, and the warning screen displays on the
monitor and blinks.
Only the alarm sounds at sub master monitor stations.
2 Press the [ OFF] button or [ REC/PLAY] button ([ OFF] but-
ton for GT-2H-L/GT-2H) to stop the alarm sound.
PRESENCE SECURITY, ABSENCE SECURITY setting (master monitor station)9-4
2 Select "SECURITY" in the "MENU" screen, and press the [
MENU] button.
1 In the standby mode, press the [ MENU] button.
4 In the "SECURITY" screen, confirm the locations that are on alert
among sensors 1 through 3 (only sensors for which security settings
have been performed will display). To change settings, move the cur-
sor to the location to be changed and press the [ MENU] button.
• Locations will display according to the locations selected when settings
were performed last.
7 PRESENCE SECURITY is set. For "ABSENCE SECURITY", "AB-
SENCE SECURITY" is set after the set time elapses.
The STATUS LED blinks with a medium interval.
• If there are no operations for approximately 1 minute, the screen display
will end.
If selected locations are open, they will display in red and "CHECK STA-
TUS SENSOR" will display on the screen.
• To cancel settings, press the [ MENU] button (cancel) at the step 3
screen.
6 Press the [ REC/PLAY] button to return to the step 3 screen, move
the cursor with "PRESENCE SECURITY" or "ABSENCE SECURI-
TY" and press the [ CALL] button.
5 Select "ENABLE" or "DISABLE" in the "SECURITY" screen for
each sensor, and press the [ MENU] button.
3 Select "PRESENCE SECURITY" or "ABSENCE SECURITY" in the
"SECURITY" screen, and press the [ MENU] button.
(Ex.: Selection of "PRESENCE SECURITY")
Set the security settings for individual doors and windows. By security
settings, intrusions at individual doors or windows will be detected and a
security alarm will sound.
• PRESENCE SECURITY
Security setting for when resident is at home sleeping that is applied im-
mediately after setting.
• ABSENCE SECURITY
Security setting for when resident is away that is applied after the delay time
(section 10-9) elapses after setting.
NOTES: 1. The alarm sound time is set in the external settings. (Refer to sec-
tion 10-5.)
The initial setting is 10 minute.
2. When the alarm sound time is set for 1 hour or for the alarm to
sound continuously, the monitor warning screen will go out after
approximately 10 minutes.
3. Even if the call tone volume is set to 0 (OFF), it will sound at a
level equivalent to 10 (HIGH).