Filter
Top Products
- 8 -
1 Press the [ ] button while in communication with the entrance sta-
tion.
Turning the entrance light on (when light is installed in common area)
1 Press the [ GUARD] button once during entrance station calling,
communication, or monitoring.
2 The outside light at the entrance will only turn on for the preset dura-
tion of time.
2 Door release is activated at the entrance station. is displayed
for approx. 5 sec. at the master monitor station. (This does not exactly
correspond to the door release status of the entrance station.)
• If the station has a camera, the door release will also activate during calling.
Depending on the electric door release system that you use, door re-
lease may be active only while the door release button is pressed.
Door release
Light control
4-2
4-3
When the specified residence is called using Doctor call (automatic en-
try), the electric lock is automatically released without a door release op-
eration from the residential station.
1
In the standby mode, press the [ GUARD] button while pressing the [
TALK] button. Press the button once more to reset the Doctor call function.
• When Doctor call is enabled, the TONE OFF LED blinks with a medium interval.
2 Press CALL button of the entrance station to unlock a door without a
door release operation from the residential station.
3 The residential station for which the Doctor call function is set is
called. Press the [ TALK] button as necessary to respond.
Doctor call (master monitor station)4-4
This function is not available if a surveillance camera is installed in
the common area.
This function may not be operated due to the equipment being used.
NOTES: When Doctor call is enabled, the TONE OFF LED function cannot be
used. (It is possible to turn the call tone off.) When calls are transferred to
the security guard station, door release with Doctor call is not possible.