Aiphone GT-2C Intercom System User Manual


 
- 10 -
1 In the standby mode, press the [ MONITOR] button to display the
video image from an individual door station. Audio can heard at the
same time. The STATUS LED will light up.
2 Press the [ MONITOR] button again to display the video image in
order from entrance 1. Audio can heard at the same time.
Listening is possible with hearing aids with T-mode. (GT-2C-L/GT-2H-L only)
1. It will take a moment after pressing the MONITOR button for the
picture to display, so please wait for the monitor picture to display
before performing the next button operation.
2. This function may not be usable depending on the equipment being
used.
The unit used in the example pictures is a master monitor station.
6
MONITORING
NOTES: 1. If there is an operation such as a call, monitoring ends and the call
operation begins.
2. If the monitor button of a residential station at another residence is
pressed, monitoring of the entrance station switches to the monitor
of the residential station where the monitor button was pressed last.
3. During monitoring, press the [
TALK] button to communicate
with the individual door station or entrance station being moni-
tored.
4. With individual door monitoring, monitoring that was initiated first
is prioritized over later attempts at monitoring. (If an attempt is
made to monitor from a sub master station during monitoring from
a master station, an alarm sound will start beeping.)
5. During monitoring, the display uses a wide picture display. (If the
[
ZOOM/WIDE] button is pressed, the display changes to the
zoom picture.)
6. When an individual door is being monitored, the illuminator LED
will not light up at night until the TALK button is pressed.
7. Monitoring will automatically end after 30 seconds.