Aiphone GT-2C Intercom System User Manual


 
- 6 -
'$7(7,0(
-$1
'$7(7,0(
-$1
0(18
6(&85,7<
*8$5'&$//
6(77,1*6
'$7(7,0(
&$//,1*(175$1&( 0$<
Setting the date and time3-2
NOTES: Operations for setting numbers
• [S] button (press once) : The date or time increases by one.
• [T] button (press once) : The date or time decreases by one.
• [W] button (press once) : The cursor moves to the left.
• [X] button (press once) : The cursor moves to the right.
• [S] button (press and hold for 1 second or more) :
The date or time increases in succession.
• [T] button (press and hold for 1 second or more) :
The date or time decreases in succession.
• [
MENU] button : The settings are fixed.
1 In the standby mode, press the [ MENU] button.
When the time is set to the initial setting, skip step 2 and go to step 3.
2 Press the [S] or [T] button to select the "DATE/TIME", and press the
[
MENU] button.
3 In the "DATE/TIME" screen, press the [S] or [T] button to select the
"Month".
4 Press the [X] button to set the "Month" and the cursor will move to
"Day".
5 Perform the same steps to set the "Day", "Year", "Hour" and "Min-
ute". After setting the "Minute", press the [ MENU] button to com-
plete the settings.
6 Press the [ OFF] button to return to the standby mode.
1. If there are no operations for approximately 1 minute during the
setup mode, the setting will end automatically. If the settings end
while incomplete, start again from the beginning.
2. A maximum error of 60 seconds can occur in the displayed time
over a month. Periodically adjusting the time setting is recom-
mended.
3. When power is not supplied to the unit for more than 30 minutes,
the set time will return to its initial setting, "JAN/01/2011 00:00",
and the STATUS LED (orange) will blink with a long interval.
4. If the security sensor is not installed, "SECURITY" will not dis-
play.
is displayed on the screen while video images are played. Press
the [
MENU] button to turn off all items displayed on the screen
(date, time, etc.) so that the entire picture is visible.
Turning off the screen display3-1