Filter
Top Products
2
Getting Started
This section describes phone behaviour and
start up screens you may see when the
9133i phone is first plugged in, or when it
is restarted.
When You First Plug in Your
Phone
The 9133i automatically begins the start up
sequence as soon as it is connected. The
phone goes through this process the first
time you plug in your phone and every time
you restart your phone. The first screen the
phone displays is the Aastra splash screen.
Updating Your Phone
After displaying the Aastra splash screen,
the 9133i checks settings and looks for new
configuration and firmware updates for the
phone from the server. If a new update is
found, the phone displays the message
<Updating Config> or <New
Firmware>. This may take a few
moments while the phone downloads the
latest updates.
NOTE: New updates to your phone can be
automatically scheduled from the server.
This is set up on the phone system by your
system administrator and should be
scheduled during non-business hours or
slow call periods.
Important! Do not unplug or remove
power to the phone while it is checking
or installing firmware.
Start up Screens
After the phone displays the Aastra
splash screen or after downloading an
update, the phone displays the Idle
State screen:
The basic Idle State screen lists your
name, extension, and today's date and
time. This screen is shown whenever
your phone is not in use.
Incomplete Config.
If your phone displays a <No
Service> message without any
extension or user name at the end of the
start up sequence instead of the Idle
State screen, this means your system
administrator has not set up your
extension correctly. Contact your
system administrator for assistance.
No Service
The <No Service> or <Network
Disconnected> prompt appears on the
display and the telephone status light turns
on when the phone is not properly
connected to the network, or the account
has not been configured by the
administrator. The phone also displays the
default time and date of 12:00am Jan 1
st
,
2000. Check that the cables are tightly
connected to the phone and to the wall jack.
The phone should automatically detect
when the connection is reconnected and
will display the <Network
Connected> prompt temporarily. If
changes have been made to your phone
settings, you may need to restart your
phone. See the following section “Setting
Your Options” for instructions on how to
restart your phone.
Getting Started