Filter
Top Products
New Features in Release 2.3
48 RN-001029-02, Release 2.3, Rev 00
IP Phone Release Notes 2.3
Configuring the Action URI Disconnect Feature Using the Aastra Web UI
Use the following procedure to configure the Action URI Disconnect feature.
Aastra Web UI
1 Click on Advanced Settings->Action URI->Event.
2 In the “Disconnected” field, enter a valid URI for which the phone executes a GET on, when it transitions from
the incoming, outgoing, calling, or connected state into the idle state. Leaving this field empty disables the Action
URI Disconnected feature. For example,
http://fargo.ana.aastra.com/disconnected.xml?state=$$LINESTATE$$
The following table lists the applicable values and descriptions for the $$LINESTATE$$.
3 Click to save your settings.
$$LINESTATE$$ Value Description Meaning in a Disconnected URI
IDLE Phone is idle. N/A
DIALING Phone is offhook and ready to
dial.
N/A
CALLING A SIP INVITE was sent but no
response was received.
Error occurred during the call.
OUTGOING Remote party is ringing. Call was cancelled.
INCOMING Local phone is ringing. Call was missed or cancelled.
CONNECTED Parties are talking. Call was successful.
CLEARING Call was released but not
acknowledged.
N/A