Aastra Telecom 9480i Telephone User Manual


 
New Features in Release 2.3
RN-001029-02, Release 2.3, Rev 00 41
SIP IP Phone Models 9143i, 9480i, 9480i CT and 5i Series Phones Release Note 2.3
XML Applications and Off-Hook Interaction
In Release 2.3, a feature has been implemented that prevents the phone from going into the
off-hook/dialing state when the handset is off-hook and the call ends.
In previous releases, the phone behaved as in the following scenario:
You are in a call using the handset and the phone displays an XML application. The far-end
terminates the call, and a new XML application gets pushed/pulled onto the display. Since the
handset is off-hook and in idle mode, the "offhook idle timer" starts. When this timer expires, the
phone applies dial tone and moves to the off-hook/dialing state, which then destroys the XML
application that was being displayed.
In Release 2.3, you can set an “auto offhook” parameter that determines whether or not the phone
is prevented from entering the off-hook/dialing state, if the handset is off-hook and the call ends.
An Administrator can enable or disable the “auto offhook” parameter using the configuration files
only.
Configuring the Off-Hook Interaction Feature
Use the following parameter to configure the XML application and off-hook interaction feature.
Parameter
auto offhook
Configuration Filesaastra.cfg, <mac>.cfg
Description Specifies whether or not the phone is prevented from entering the off-hook/
dialing state, if the handset is off-hook for more than 2 seconds, and the call
ends.
Format Boolean
Default Value 0 (disabled)
Range 0 (disabled)
1 (enabled)
Example auto offhook: 1