Filter
Top Products
New Features in Release 2.3
RN-001029-02, Release 2.3, Rev 00 47
SIP IP Phone Models 9143i, 9480i, 9480i CT and 5i Series Phones Release Note 2.3
Example
If you enter the following string on Phone A for the “action uri disconnected” parameter:
action uri disconnected: http://fargo.ana.aastra.com/
disconnected.xml?state=$$LINESTATE$$
and then Phone A calls Phone B, Phone B answers and then hangs up, Phone A executes a GET
on:
http://fargo.ana.aastra.com/disconnected.xml?state=CONNECTED
which is what the remote server receives.
An Administrator can enable the disconnect feature using the configuration files or the Aastra Web
UI.
Configuring the Action URI Disconnect Feature Using the Configuration Files
Use the following parameter to configure the Action URI Disconnect feature.
Note: If the phone can’t find the Action URI you specify, it returns a
“NULL” response. For example,
http://fargo.ana.aastra.com/disconnected.xml?state=
Parameter–
action uri disconnected
Aastra Web UI Advanced Settings->Action URI->Event
Configuration Files aastra.cfg, <mac>.cfg
Description Specifies the URI that the phone executes a GET on, when it transitions from
the incoming, outgoing, calling, or connected state into the idle state.
This parameter uses the following variable to determine the state of the line:
$$LINESTATE$$
Format String
Default Value Blank
Range Any valid URI
Example action uri disconnected: http://fargo.ana.aastra.com/
disconnected.xml?state=$$LINESTATE$$