Filter
Top Products
Changes in 1.4.2, Build 3000
RN-001033-00, Rev 01, Release 1.4.2 3
SIP IP Phone Models 480i, 480i CT, 9112i, 9133i Release Notes
Changes in 1.4.2, Build 3000
This section describes the feature enhancements, and issues resolved, in Release
1.4.2, build 3000.
Enhancements to “Incoming Call Interrupts Dialing” Feature
The “Incoming Call Interrupts Dialing” feature has been enhanced to work
more efficiently.
In previous releases, if the “Incoming Call Interrupts Dialing” feature was
disabled, and you were dialing out on your phone, and you received an incoming
call at the same time, the incoming call would go to an available line and the LED
would blink to let you know where the call was placed by the phone. The Caller
ID would display on the LCD and the number you were dialing disappears. If you
wanted to continue dialing out, you would have to press the Line key for which
you were originally dialing out on. If “Incoming Call Interrupts Dialing” is
enabled, the incoming call interrupts your dialing sequence and displays to the
phone’s LCD for you to answer.
In Release 1.4.2, Build 3000, the behavior for “Incoming Call Interrupts Dialing”
has been modified. Now when this feature is disabled, the incoming call goes to
an available line, the LED blinks, but the LCD screen still displays the number
you were dialing. When this feature is enabled, it performs the same as in previous
releases.
Transfer/Conference Call Behavior
If you are dialing the phone to transfer or conference a call, and your phone
receives an incoming call, your dialing is never interrupted (regardless of
whether the “Incoming Call Interrupts Dialing” is enabled or disabled). For
Transfer and Conference, the incoming calls always go to an available line
(other than the one you are using for dialing) and the incoming call’s line
LED blinks. The LCD still displays your dialing screen.