Filter
Top Products
Changes in 1.4.2, Build 3000
4 RN-001033-00, Rev 01, Release 1.4.2
IP Phone Release Notes 1.4.2
Intercom Behavior
If “Incoming Call Interrupts Dialing” is enabled and you are dialing an
outgoing Intercom call, the enabled interrupt setting takes precedence over an
enabled “Allow Barge In” setting. The incoming call interrupts your dialing on
an outgoing intercom call. On an incoming intercom call, the enabled “Allow
Barge In” and “Auto-Answer” occurs while you are dialing to transfer or
conference the call. However, the incoming call goes to an available idle line, and
the LED blinks while you are dialing the second half of the conference or transfer.
If “Incoming Call Interrupts Dialing” is disabled, an incoming intercom goes to
an available idle line and the LED blinks for that line. The phone answers the call
under all conditions.
Issues Resolved in 1.4.2, Build 3000
This section describes the issues resolved in Release 1.4.2, build 3000. The
following table provides the issue number, and a brief description of each fix.
Issue Number Description of Fix
CLN07721 The “Incoming Call Interrupts Dialing” feature has been enhanced to work more
efficiently.
For example, if the phone receives an incoming call while you are dialing an
outgoing call, and “Incoming Call Interrupts Dialing” is disabled, the incoming call
goes to an available line, and the LED blinks. However, the phone UI continues to
display the number you are dialing. (Incoming calls do not take precedence over
outgoing calls.)
CLN07805
If you place a call on hold, and then press a Conference softkey, the call
now remains on hold; the phone does not send dtmf digits over this line.
DEF07059 When you press the Mute button on the IP phone, the phone UI now displays
“Mute,” and the LED flashes, notifying you that the mute feature is now active. Prior
to this release, the phone UI would display “Connected.”