Filter
Top Products
Changes in 1.4.2, Build 1081
8 RN-001033-00, Rev 01, Release 1.4.2
IP Phone Release Notes 1.4.2
ENH05218 A User and Administrator can now configure whether or not an incoming call
interrupts an outgoing call that is dialing. A new parameter has been added
(“incoming call interrupts dialing”) to control this feature.
When you enable this parameter (1 = enable), an incoming call interrupts the
outgoing call during dialing and allows the phone to ring for the user to answer the
incoming call. This was the existing default behaviour in the previous 1.4.1 release
and is also the behaviour of this parameter in 1.4.2 if it is enabled.
IMPORTANT NOTE: If you disable this parameter, the behaviour of the phone has
changed in 1.4.2. In 1.4.2, this feature performs as follows if disabled:
When you disable the “incoming call interrupts dialing” parameter (0 = disable),
which is the default, the phone does not interrupt the outgoing call during dialing and
instead rings the incoming call on another free line (or sends busy signal if all
remaining lines are busy). You have a choice to ignore the incoming call, or answer
the incoming call on another line. If you choose to answer the incoming call, you can
answer the call, finish the call, and then hang up. You can still go back to the original
outgoing call and finish dialing out.
On the 480i, 480i CT, and 9133:
If you disable this parameter (0=disable), and the phone receives an incoming
call while you are dialing an outgoing call, you can pick up the call and perform
transfer or conference as required.
On the 9112i:
If you disable this parameter (0=disable), and the phone receives an incoming
call while you are dialing an outgoing call, you can pickup the call but you
cannot transfer or conference that call.
An Administrator can set this parameter using the configuration files (incoming call
interrupts dialing) or the Aastra Web UI (Incoming Call Interrupts Dialing) at
Basic Settings->Preferences->General). A User can set this parameter using only
the Aastra Web UI.
Issue Number Description of Fix
Incoming Call Interrupts Dialing (in Web UI) (Default is disabled.)