Filter
Top Products
9
Making and Answering Calls
Muting a handsfree call
You can turn off the microphone so that the caller can’t hear you but you can still hear
the caller. Muting a call only works when you are in Handsfree mode.
Using Redial
Pressing Redial dials the last number dialed.
Adjusting the Handset and Speaker volume
Press the left or right side of the volume bar
R
to adjust the volume on
the handset or speaker. The handset volume resets to factory set volume level after
each call. The speaker volume remains at the level selected until the next time
you change it.
Adjusting the Ringer Volume
The ringer volume is controlled by a three position switch on the side of the Model
9110. The ringer volume can be set to low, medium, or high.
Set Indicator Light
The set indicator light, located on the top right hand corner of the Model 9110, flashes
and illuminates to provide information as follows:
To mute a handsfree call:
1. Press
c
.
2. Without lifting the handset, make a call.
3. To turn off the microphone, press
c
. You can hear your caller but your
caller cannot hear you. The light next to the key will flash to indicate the mute is
on.
4. To speak to your caller, press
c
again. Each time you press
c
, you
turn the microphone on or off.
5. When the call is over, press
N
.
To make a call using Redial:
1. Lift the handset or press
c
.
2. Press
b
.
Set indicator light flashes very quickly.
Incoming call.
Set indicator light flashes quickly.
(2 pulse/sec.)
Line is on HOLD.
Set indicator light flashes slowly.
(1 pulse/sec.)
Message Waiting*.
9110 E2 UG.fm Page 9 Friday, May 21, 2004 9:39 AM