Filter
Top Products
220 Model 6757i CT IP Phone User Guide
Accessing Options on the Cordless Handset
Feature Key Programming Guidelines
The following are guidelines to use when programming the feature keys on the handset:
• All handsets paired with the same Base Station have the same programmed functions since
the web interface applies the functions to all the handsets paired with that base.
• A newly registered handset or handset that was out-of-range during the programming needs
to perform an "off-hook and on-hook" sequence in order for the newly programmed function
to be broadcast to the affected handsets. Simply press the v key from the idle state to go
off-hook. Then, press the
y key to go back on-hook.
• Duplicate functions can exist in the feature key as there is no filtering or duplicate checking
done on the handset or the base.
• If no line keys are programmed for the feature key, the handset is restricted to intercom calls
only.
• If all 15 Handset Keys have been programmed to "None", the user is presented with a List
empty message when the feature key is pressed.
• For security reasons, the user has 180 seconds (3 minutes) to complete the programming.
Otherwise, the phone displays the following error:
** Error **: Session expired, Please reload page.
• For security reasons, the user must submit the page from the same browser that was used to
load the page. If the user tries to submit the page from any other IP address, the following
error displays: ** Error ** Session invalid. Different Client IP Addresses. — Please reload
page.
Private/Public Indicates the key is configured for either Private or Public use. You can
toggle between Private and Public as required. Default is Private.
Note: “Private” is the default setting on the Handset. The “Private/
Public” option is available only when multiple handsets are paired with
the same base.
In “Public” mode, all handsets paired with the same base can share
calls. In this mode, a triangle indicator illuminates in front of the Public
label in the feature list on the Handset. You can toggle between Public
and Private as required. The Base Unit displays “Private” on a softkey
allowing you to toggle between Public and Private.
In “Private” mode set on a specific Handset, all calls are made private
to that Handset only. No calls are shared.
Flash Indicates the key is set to generate a flash event when it is pressed on
the 6757i CT. The IP phone generates flash events only when a call is
connected and there is an active RTP stream (for example, when the
call is not on hold).
Key Function Description
List empty
Use web page to
configure