Filter
Top Products
Operational Features
5-110 41-001129-00 Rev 09, Release 1.4.1
IP Phone Administrator Guide
Operational Features
Configuring the SIP Local Dial Plan
Use the following procedures to configure the SIP Local Dial Plan using the
configuration files or the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “SIP Local Dial
Plan Settings” on page A-32.
Aastra Web UI
1 Click on Basic Settings->Preferences.
2 In the "Local Dial Plan" field, enter a valid local dial plan (up to 127 alphanumeric characters) for the
IP phone. Default is X+#|XX+*. Enter prepended digits as required.
3 Enable the "Send Dial Plan Terminator" field by checking the check box. (Disable this field by
unchecking the box). Default is disabled.
4In the "Digit Timeout (in seconds)" field, enter a timeout value. This is the length of time the phone
waits before dialing. Default is 4 seconds.
5 Click to save your changes.
You must restart your IP phone for the changes to take affect.