Filter
Top Products
62 CHAPTER 5: BASIC TELEPHONE OPERATION
coverage point is your voice mailbox. The call coverage point is set
through the VCX User Interface (see Chapter 8
).
When your telephone is in Do Not Disturb mode:
■ An incoming call does not cause your phone to ring. If you are logged
in to multiple phones using the same phone number and one of the
phones enables Do Not Disturb, the feature applies to all phones—an
incoming call will not ring on any of the phones.
■ You can use the phone to dial outgoing calls.
■ If you enable Do Not Disturb while one or more calls are ringing, the
pending calls are sent to your call coverage point and Do Not Disturb
is enabled for all subsequent calls.
■ If you are a Hunt Group member and you enable Do Not Disturb,
personal (non-Hunt Group) calls go to your call coverage point.
However, Hunt Group calls always ring on a member’s phone,
regardless of the Do Not Disturb setting.
If your telephone is part of a bridged extension, see Do Not Disturb and
Bridged Line Calls for additional information.
To activate Do Not Disturb:
1 Press the Do Not Disturb Access button on the phone. The red light is lit
next to the Do Not Disturb button (Model 3102 only).
Your telephone is now in Do Not Disturb mode. The display panel shows
DND.
2 To disable Do Not Disturb mode, repeat step 1. The DND message
disappears from the display panel and the red light goes out.