Motor
POWER Cord Length Protector Bare Floor Tool Caddy Headlight
120 V. AC (60Hz)
25 ft. (7.6 m) Yes Yes Yes Yes
12.0 A
IExtensión Protector Uso sin Caja de
Voltaje
de cordón
de motor
alfombra
herramientas Luz
120 V AC (60Hz)
7,6 m (25 pi) Si Si Si Si
12,0 A
Longueur Protecteur Position Porte- Dispositif
Alimentation du cordon du moteur plancher accessoires d’éclairage
120 V c.a. (60 Hz)
7,6 m (25 pi) Oui Oui Oui Oui
12,0 A
- 42 -
FEATURE CHART
Diagrama de características
Tableau des caractéristiques
-11 -
If the vacuum should become clogged:
➢➢
Ensure ON-OFF switch is OFF.
➢➢
Disconnect power cord from electrical
outlet.
➢➢
Pull open suction inlet cover and
remove any clogs.
➢➢
Check the nozzle hose to make sure
it is free from obstructions.
➢➢
The nozzle hose may be removed at
the wand attachment end in order to
remove clogs.
➢➢
Check and replace any clogged
filters.
➢➢
Clean agitators.
Removing Clogs
➢➢
Remove the screw that secures the
handle to the vacuum.
➢➢
Insert flat screwdriver into locking
tab release hole located just in front
of the handle tube, pry screwdriver
toward the front of the vacuum.This
should release the handle locking tab
allowing the handle to be pulled from
the vacuum.
➢➢
Remove handle assembly by pulling
straight out of vacuum.
