7. Programmable Features
38
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=2 [±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “2” (default), “3”, “4”, “5”, “6”, “7”,
“8” or “9”. If you are using the unit with an
answering machine, set to more than 4 (page
32).
Code #12: Enabling remote operation for an
answering machine
REMOTE TAM ACT.
=OFF [±]
If you are using the unit with an answering
machine, activate this feature, and program the
remote activation ID to enable remote operation
of the answering machine.
1. Press {MENU}.
2. Press {#} then {1}{2}.
3. Press {A} or {B} repeatedly to select “ON”.
4. Press {SET}.
5. Enter your ID from 1 to 5 digits, using 0–9,
{*} and {#}.
L The default ID is “11”.
6. Press {SET}.
7. Press {MENU}.
Code #13: Setting the dialling mode
(For Australian users only)
DIALLING MODE
=TONE [±]
If you cannot dial, change this setting depending
on your telephone line service.
“TONE”(default): For tone dial service.
“PULSE”: For rotary pulse dial service.
Code #17: Setting the ringer pattern
RINGER PATTERN
=A [±]
You can select “A” (default), “B” or “C”.
7.3 Advanced features
Code #22: Setting the journal report to print
automatically
AUTO JOURNAL
=ON [±]
“ON” (default): The unit will print a journal report
automatically after every 30 new fax
communications (page 27).
“OFF”: The unit will not print a journal report, but
will keep a record of the last 30 fax
communications.
Code #23: Sending documents overseas
OVERSEAS MODE
=ERROR [±]
If you have difficulty sending an overseas fax,
activate this feature before starting transmission.
L This feature is not available for broadcast
transmission.
L The calling charge may be higher as the
transmission speed is slowed down.
“NEXT FAX”: This setting is effective only for the
next attempted fax transmission. After
transmission, the unit will return to the previous
setting.
“ERROR” (default): When the previous fax
transmission fails and you wish to re-send the
document automatically.
“OFF”: Deactivates this feature.
Code #25: Sending a fax at a specific time
DELAYED SEND
=OFF [±]
This feature allows you to take advantage of low-
cost calling hours offered by your telephone
company. This feature can be set up to 24 hours
in advance of the desired time.
To send a document:
1. Insert the document.
2. Press {MENU}.
3. Press {#} then {2}{5}.
4. Press {A} or {B} repeatedly to select “ON”.
5. Press {SET}.
6. Enter the fax number.
7. Press {SET}.
8. Enter the transmission start time.
L Press {*} repeatedly to select “AM” or
“PM”.
9. Press {SET}.
L To cancel after programming, press {STOP}
then {SET}.
Code #26: Setting the Caller ID list to print
automatically
AUTO CALL. LIST
=ON [±]
FL511AL.book Page 38 Tuesday, October 7, 2003 2:18 PM
