2009 by Panarex Electronics
Operating Principle
▪ Select an item by using up and down key and change the value of the highlighted (selected) item by using keys shown
on the screen. Press OK to enter to the sub-menu if there is no instruction marks on the screen.
▪ The item is automatically stored and moved the upper menu by pressing the ‘EXIT’ key
▪ You can return to normal mode at any time by pressing the menu key from the menu mode
Universal Remote Interface Programming
A) Manual Code Input Method
1. Turn the TV set power on.
2. Press remote TV button for 5 seconds until TV button LED red light on.
3. While LED red light on (within 10 seconds), aim remote to the TV set and enter 3 digit code in the list.
If the code is a matched one, red light will flash 3 times and the TV set power will be turned off automatically. If red
light does not flash, try another 3 digit code one by one.
4. For other AUX products, follow same as above steps.
B) Automatic Code Search Method
1. Turn the TV set power on.
2. Press remote TV button for 5 seconds until TV button LED light on.
3. While LED red light on (within 10 seconds), aim remote to the TV set and press and release UP( ▲ ) button and wait
3 seconds. If auto search code is a matched one, red light will flash 3 timesand the TV set power will be turned off
automatically.
If no response within 3 seconds, press and release UP( ▲ ) button again and wait 3 seconds for another code search.
Continue this procedure until you get the response.
4. For other AUX products, follow same as above steps.
Custom Code Programming
When the remote control interfering TV (AUX) set at “STB” operation position, program another code among 3 different
codes to avoid the problem.
Press OK and number 2 (or 3) button simultaneously about 5 seconds until STB button red light flash 3 times.
