Zyliss TH106 Two-Way Radio User Manual


  Open as PDF
of 4
 
Please note: the TH106 comes factory set in baseboard
mode. If using the TH106 to control a fan-forced heater, you
must change the setting.
To change the setting: The configuration switches are on
the back of the thermostat. Change factory setting SW3 to the
‘ON’ position (15 minute cycle length). See page two of your
thermostat Owner’s Guide, Section 3, Item CONFIGURATION
for more detailed instructions.
PN 720018
Switch to
“ON” for
Fan Setting
Factory
Setting
Instructions are also available on our website at www.cadetco.com
Cycle
length
15
seconds
Baseboard
15
minutes
Fan
Heater
SW3
IMPORTANT INSTRUCTIONS
for FAN-FORCED HEATER USE
next