Filter
Top Products
Vox Function (continued)
4). When activating the VOX after is has turned off, a delay of 3 seconds is required
before resuming conversation. The activation of the VOX will provide a sound in
the headset.
5). Depending on the helmet type and motorcycle, ambient noises could activate the
VOX at higher speeds (~60 MPH). In that case, please protect the microphone as
much as possible from ambient noises and lower the microphone sensitivity. If you
ride for long hours at high speeds, we recommend that you switch off channel 2
at one headset. If the channel is switched on again, the headsets are paired and
the communications can resume.
Adjustment of microphone sensitivity
If the VOX does not function appropriately, the microphone sensitivity should be adjusted.
The individual adjustment depends on the helmet, riding conditions, and the voice level.
1). Press [+] & [-] keys simultaneously for 6 seconds (from a power off status). Release
the keys.
2) Adjustments
Low: 4x flashing within 2 seconds
Middle: 2x flashing within 2 seconds
High: 1 long flash for 2 seconds
Repeat key presses until adjustment level desired.
Pairing of headsets on channel 2
Before you start to pair the headsets on channel 2, please switch off channel 1 as well as
all other Bluetooth devices in your environment.
1). Headset 1: Press the [+] key for 7 seconds (from a power off status) until the
green LED starts flashing rapidly. This headset will be the SLAVE.
Headset 2: Press the [M] key and the [+] simultaneously for 7 seconds until the
green LED starts flashing rapidly. This headset will be the MASTER.
2). As soon as the headsets have paired, the green LEDs will flash slower.
3). As long as the headsets have not been reset, they will connect automatically with
each other every time you turn them off then on again.
Intercom Function Intercom Function
24 25