VTech VT 2931 Cordless Telephone User Manual


 
27
operation, or procedures that could affect the operation of your equipment. If so, you will
be given advance notice of the change to give you an opportunity to maintain uninterrupted
service.
The base unit contains no user serviceable parts. The handset contains a user
replaceable battery pack.
If it is determined that your telephone equipment is malfunctioning, the FCC requires that
it not be used and that it be unplugged from the modular jack until the problem has been
corrected. Repairs to this telephone equipment can only be made by the manufacturer
or its authorized agents or by others who may be authorized by the FCC. For repair
procedures, follow the instructions outlined under the manufacturer’s Limited Warranty.
This equipment may not be used on coin service provided by the phone company or Party
Lines.
The REN is useful in determining the number of devices you may connect to your
telephone line and still enable the devices to ring when you receive a call. The general
rule is that the REN value should not exceed 5.0 total; however, contact your local
telephone company for the specific number in your area.
IC (Industry Canada)
This telephone is registered for use in Canada.
Notice: The REN assigned to this device denotes the number of devices you may
connect to the telephone loop, which is used by the device to prevent overloading,
The termination on a loop may consist of any combination of devices subjected
only to the requirement that the sum of the REN does not exceed five (5.0)
Notice: The Industry Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective,
operational and safety requirements. The Department does not guarantee the
equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected
to the facilities of the local telecommunications company. The equipment must also be
installed using an acceptable method of connection. The customer should be aware that
compliance with the above conditions may not prevent degradation of services in some
situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance
facility designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company cause
to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the
power utility, telephone lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but shoul
contact the appropriate electrical inspection authority, or electrician, as
appropriate.
FCC AND IC REGULATIONS
ADDITIONAL INFORMATION