Filter
Top Products
4
Getting Started
Installation
Before You Install
1. Choose a location for the Base near an electrical outlet and a telephone
jack. This phone requires a modular telephone jack and a standard
electrical outlet (110V AC) not controlled by a wall switch.
2. Install the Handset battery. Use only VTech batteries.
3. Attach the Belt Clip to the Handset (optional).
NOTE: Install the Base Unit away from electronic equipment, such as personal
computers, television sets or microwave ovens. Avoid excessive heat, cold, dust
or moisture.
a) Remove battery
compartment cover by
pressing on the indentation
and sliding downward.
b) Align the two holes in the plug with the
socket pins, then snap the plug into place.
c) Place the battery in the compartment
with the wires in the lower right corner.
Angle the top of the battery under the top
claws first, then snap the bottom of the
pack in. Place the wires under the guide,
located below the battery.
d) Replace the battery compartment cover.
To Attatch To Remove