VTech LS6125-2 Cordless Telephone User Manual


 
www.vtechphones.com
58
Troubleshooting
Problem Suggestion
The answering system
does not answer after
the number of rings
which I programmed it.
Make sure the answering system is on. When the answering system is on, the red light on the
ANS ON/OFF key should be lit.
If Toll Saver is activated, the number of rings changes to two when there are new messages
waiting (page 35).
If the memory is full or if the answering system is off, the system will answer after ten rings.
In some cases, the answering system will be affected by the ringing system used by the local
telephone company.
The outgoing
announcement is not
clear.
When recording the announcement, make sure you speak in a normal tone of voice about nine
inches from the telephone base.
Make sure there is no background noise (television, music, trafc, etc.) when recording.
The messages on the
system are very difcult
to hear.
Press VOL on the telephone base to increase the speaker volume.on the telephone base to increase the speaker volume.
The answering system
does not record
messages.
Make sure the answering system is on.
If the answering machine memory is full, it will not record new messages until some old
messages are deleted.
The messages on the
answering system are
incomplete.
If a caller leaves a very long message, part of it may be lost when the system disconnects the
call after four minutes.
If the memory on the system becomes full during a message, the system stops recording and
disconnects the call.
If the caller’s voice is very soft, the system may stop recording and disconnect the call.