Filter
Top Products
7
Setup
Getting Started
Battery Life
A fully charged battery provides an average talk time of about 8 hours or
standby time of 5 days.
NOTE: Talk time and standby time may vary depending on operating conditions.
Battery Indicator
Ten minutes before the battery charge level gets too low to operate the Hand-
set, an empty battery icon will start flashing, five short tones are generated, and
a LOW BATTERY message is displayed.·
If you continue to use the Handset without charging or replacing the battery
(spare battery purchased separately), the Handset will turn off automatically
when the battery charge level is no longer sufficient to power up the Handset,
and the call will be dropped.
Charging the Handset Battery Pack
After a low battery indication, place the Handset in the charger, and ensure that
the CHARGING light turns on.·
With the exception of the first charge, the battery pack is typically charged in 8
hours.
NOTE: If you repeatedly get a low battery indication, even after 8 hours of charg-
ing, then the battery should be replaced.
As you register additional Handsets to VT5831 or i 5881 system, they will be
assigned extension numbers in the following order: HANDSET 2, HANDSET
3, HANDSET 4, and so forth.
Whenever a charged Handset battery pack is installed, the Handset will
automatically begin Searching For Base... (if previously registered), or it will
prompt you to Enter Base ID to register the new Handset.
BEFORE USING YOUR HANDSET(S), CAREFULLY PEEL OFF THE
PROTECTIVE FILM, COVERING THE DISPLAY.