Filter
Top Products
9
Connecting to Phone Line
Plug one end of the telephone line cord into the jack
on the bottom of the Base Unit. Plug the other end of
this cord into the wall jack.
Checking for Dial Tone
After the battery is charged press
ON
on the Handset.
The Phone icon
will appear on the Handset
display, and you will hear dial tone. If not, see
In
Case of Difficulty.
CAUTION: Use only the VTech power supply provided with your telephone.
IMPORTANT:
1. Do not dispose of a battery pack in a fire, the cell may explode.
2. Do not open or mutilate the battery pack. Toxic substances may be released,
causing harm to eyes or skin.
3.
4.
Setup
IMPORTANT:
FOR MAXIMUM PERFORMANCE
OFYOURCORDLESS TELEPHONE SYSTEM:
1.
2.
3.
4.
5.
Getting Started
i 5886 manualNov11.p65 11/12/2003, 9:50 AM9
Exercise care in handling battery packs in order to prevent an accidental short
of the charge contacts, potentially causing the battery pack to overheat.
Do not dispose of this battery pack into household garbage.
Tone/Pulse Selection
Your i 5836 is preset for tone dialing. If you want to change
your dialing mode, see the Tone/Pulse section for details.
Choose a central location for your Base Unit.
Install your Base Unit and Extension Handsets
away from electronic equipment, such as
personal computers, television sets and
microwave ovens.
In locations where there are multiple cordless
telephones, separate Base Units as much
as possible.
Install your telephone equipment away from
heat sources and sunlight.
Avoid excessive moisture, dust or extreme
cold.