Filter
Top Products
2
Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service
through your telephone line, you must install a DSL lter between the
telephone line cord and telephone wall jack. The lter prevents noise and
caller ID problems caused by DSL interference. Contact your DSL service
provider for more information about DSL lters.
Use only the power adapters and batteries supplied with this product.
To order a replacement, visit our website at www.vtechphones.com or
call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The power adapters are intended to be correctly oriented in a vertical
or oor mount position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling, under-the-table or cabinet outlet.
•
•
Wall mounting
Your telephone comes ready for tabletop use. If you prefer to mount
your telephone on the wall (optional), it is designed to mount on a
standard telephone wall plate.
You can mount the telephone base on
the wall by positioning the top hole at the
back of the telephone base against the
top mounting stud [A]. Then slide the
telephone base down on the
mounting studs [A] and [B]
until it locks into place.
Telephone base
Telephone
line cord
Electrical outlet
(not controlled
by a wall switch)
Telephone
wall jack
A DSL lter (not
included) is
required if you have
DSL high-speed
Internet service
Telephone base
power adapter
Charger
Charger
adapter
CAUTION: If you subscribe to telephone service from a cable company
or a VoIP service provider, contact your cable/VoIP service provider for
more information.
Mounting
studs
Telephone base
[A]
[B]