VTech CS5123 Telephone User Manual


 
www.vtechphones.com
32
Answering system
If you have caller
ID service the
clock will be set
automatically with
incoming calls,
but you will need
to make sure the
year is correct.
Press and hold
/SKIP or
/REPEAT
while setting
the minutes or
year to advance
or decrease by
increments of ten.
Activate the answering system
The answering system must be turned on to answer and record messages.
If the answering system is turned on, the ANS ON/OFF light will be on. Press
ANS ON/OFF to turn the answering system off or on.
Set the clock
Before playing each message, the answering system announces the day and
time of the message received. Before using the answering system, set the day,
time and year, so that messages are dated correctly. If the clock is not set before
new messages are recorded, the system will announce “Time and day not set.”
before each message is played to remind you to set the clock.
Press CLOCK. The system announces the clock setting (e.g. day, time and
year), then announces: “To set the clock, press CLOCK.”
Press CLOCK. The system announces the current day.
Press /SKIP or /REPEAT until the system announces the correct day, then
press CLOCK. The system announces the current hour.
Press /SKIP or /REPEAT until the system announces the correct hour, then
press CLOCK. The system announces the current minute.
Press /SKIP or /REPEAT until the system announces the correct minute,
then press CLOCK. The system announces the current year.
Press
/SKIP or /REPEAT
until the system announces the correct year, then
press CLOCK. The system announces the current clock setting and exits the
clock menu.
1.
2.
3.
4.
5.
6.