Filter
Top Products
14
Basic Operation
Telephone Memory
1 1
2 A B C 2
3 D E F 3
4 G H I 4
5 J K L 5
6 MNO6
7 PQRS7
8 T U V 8
9 W X Y Z 9
0 0
**
# & ’ ,-.#
Presses
Dial Key 1 2 3 4 5 6
You can store up to nine numbers with names (up to 15 characters and 24 digits in each
location) you dial frequently into the speed dial memory locations you assign (1 through
9) in each handset. You can also store telephone numbers with names alphabetically in
the directory. See Telephone Directory for instructions.
NOTES:
• The entries you stored in speed dial memory will be marked with 01 through 09 in the
telephone directory.
• Press OFF at any time to exit memory dial mode.
Store a Number/Name in Memory:
1. Press PROG on the handset.
2. Press or until the screen displays SPEED DIAL.
3. Press SEL. The screen displays ENTER 1-9.
NOTE: When memory is full the screen displays MEMORY FULL, an error tone sounds,
and you cannot store a new number until you delete a record in speed dial memory or
telephone directory.
4. Press the key (1 through 9) for the memory location where you want to store this
entry.If the selected location is empty, the screen displays ENTER NAME.
NOTE: If the location is not empty, your new entry will be stored in place of the old and the
first entry will be deleted. Take caution to not save over entries you do not wish to delete
from memory.
5. Using the chart below, enter up to 15 characters for the name you’re storing with the
number. Use to backspace and make corrections; use to advance and add a
space.