Filter
Top Products
13
Your VT5831 Handset comes registered to
the Base Unit. To register additional VT5820
Handsets, follow these steps:
Enter Base ID Code
1. After charging the Handset, remove it
from its Charge Cradle; the screen will
display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. You will now see the ENTER
BASE ID screen as described in step 1.
Registration and Operation
GETTING STARTED
*
4. Find the BASE ID Code by doing the following: (the Base must be in idle (OFF)
mode)
A. At the Base, press MENU
B. Scroll down to DISPLAY BASE-ID
C. Press OK. The Base screen will display the 15-digit ID Code. Afterwards,
it will return to the idle screen.
5. Enter the 15-digit Base ID Code into the Handset; then press OK.
NOTE: The 15-digit BASE ID Code may contain numbers and characters, such
as . Make sure you enter all 15 digits.
6. Wait approximately 15 to 60 seconds. You will hear confirmation beeps from
the Base and Handset. The newly registered Handset will now assign itself the
lowest Handset number not previously assigned to a different system Handset
(1 through 6).
7. If the Handset displays REJECTED BY
BASE or continues to display
SEARCHING FOR BASE for well beyond
60 seconds, try the registration process
again by repeating the above steps.
Congratulations! You can now enjoy the benefits of your VTECH Multi-Handset system.