Filter
Top Products
6
Registration
Enter Base ID Code
1. After charging the Handset, remove it from its
Charge Cradle; the screen will display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. You will now see the ENTER
BASE ID screen as described in step 1.
4. Find the BASE ID Code by doing the following: (the Base must be in
idle (OFF) mode)
A. At the Base, press MENU
B. Scroll down to DISPLAY BASE-ID
C. Press OK. The Base screen will display the 15-digit ID Code.
Afterwards, it will return to the idle screen.
5. Enter the 15-digit Base ID Code into the Handset; then press OK.
NOTE: The 15-digit BASE ID Code may contain numbers and
characters, such as . Make sure you enter all 15 digits.
6. Wait approximately 15 to 60 seconds. You will hear confirmation beeps
from the Base and Handset. The newly registered Handset will now assign
itself the lowest Handset number not previously assigned to a different
system Handset (1 through 6).
7. If the Handset displays REJECTED BY BASE
or continues to display SEARCHING FOR
BASE for well beyond 60 seconds, try the
registration process again by repeating the
above steps.
Congratulations! You can now enjoy the benefits of your VTECH Multi-Handset
system.
*