Filter
Top Products
Install Your Viking Product in a Weatherproof Enclosure
The VE-9x12 and VE-9x20 provide the ultimate in
weather protection for your Viking product!
The enclosures are constructed of cast aluminum and is
made for years of outdoor service. The heavy-duty alu-
minum door is labeled “Telephone” and has a gasket
seal to keep out even the harshest weather. The VE-
9x12 and VE-9x20 are available in two high visibility col-
ors: safety yellow or emergency red.
For more information on the VE-9x12 or VE-9x20,
retrieve Fax Back Document 413.
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or
subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate
such changes.
Fax Back Doc 360
ZF300950 Rev G
Printed in the U.S.A.
The K-1900 Series phones is factory set to restrict fraudulent calls from hand held pocket dialers. After speed dialing,
the K-1900 Series phones will restrict (hang up) when they detect any Touch Tone that they did not generate. To restrict
user dialing, enter
✱3 while in the programming mode. To enable user dialing, enter ✱4 while in the programming mode.
G. Touch Tone User Dialing Restriction (factory enabled)
An optional Q170600 internal ringer is available. For more informa-
tion, retrieve Fax Back Document 834.
T
R
.47 mF @ 250V
(included with ringer)
Q170600
Electronic Ringer
A
A
d
d
d
d
i
i
n
n
g
g
a
a
n
n
I
I
n
n
t
t
e
e
r
r
n
n
a
a
l
l
R
R
i
i
n
n
g
g
e
e
r
r
R
R
e
e
l
l
a
a
t
t
e
e
d
d
P
P
r
r
o
o
d
d
u
u
c
c
t
t
s
s
Vandal Resistant Hot-Line Panel Phone with Touch Tone Keypad
The K-1900-8 Stainless Steel Panel Phone features a built-in Hot-Line dialer as well as a weather resist-
ant keypad. The dialer can provide both Touch Tone dialing as well as 10/20 pps pulse dialing. After the
phone number has been dialed, the Touch Tone keypad is enabled to permit additional manual dialing.
The K-1900-8 housing consists of a heavy gauge, stainless steel panel, a metal Touch Tone keypad, an
armored cable, and an all metal cradle for both weather and vandal resistance.
For more information on the K-1900-8 Hot-Line Panel Phone, retrieve Fax Back Document 312. For
more information on the VE-Series Surface Mount Boxes, retrieve Fax Back Document 424.
Weatherproof
Enclosures
P
P
r
r
o
o
d
d
u
u
c
c
t
t
S
S
u
u
p
p
p
p
o
o
r
r
t
t
L
L
i
i
n
n
e
e
.
.
.
.
.
.
7
7
1
1
5
5
.
.
3
3
8
8
6
6
.
.
8
8
6
6
6
6
6
6
F
F
a
a
x
x
B
B
a
a
c
c
k
k
L
L
i
i
n
n
e
e
.
.
.
.
.
.
7
7
1
1
5
5
.
.
3
3
8
8
6
6
.
.
4
4
3
3
4
4
5
5
K-1900-8
Shown with VE-5x10
F. Touch Tone or Pulse Dialing
The K-1900 Series phones are factory set to automatically dial using Touch Tones. A✱6 entered in the speed dial num-
ber will toggle the dialing mode between Touch Tone and pulse (see section C).
Note: You can NOT program a
✱
and # to be pulse dialed.
E. Security Code
A six digit security code is required to access the programming mode. The factory set security code is 845464 (V-I-K-
I-N-G). It is recommended that you change the security code to a personal 6 digit (0-9) number in memory position #9
while in the programming mode. Note: The security code must be six digits in length and cannot contain a
✱
or #.