18
TROUBLESHOOTING
YOUR NEW PHONE
If your XS610 cordless telephone is not performing to your expectations, please try
these simple steps first before calling Uniden customer service.
Caution: Do not attempt to service this until yourself. Servicing must be performed by
qualified personnel.
TROUBLE SHOOTING
Charge light won’t
come on when
handset is placed
in base.
● Make sure the AC adaptor is plugged into the base and
wall outlet.
● Make sure the handset is properly seated in base.
● Make sure the charging contacts on the handset and base
are clean.
PROBLEM
The audio sounds
weak and/or
scratchy.
Can’t make or
receive calls.
The handset
doesn’t ring or
receive a page.
● Check both ends of the base telephone
line cord.
● Make sure the AC adaptor is plugged into the base and
wall outlet.
● Disconnect the AC adaptor for a few minutes, then
reconnect it.
● Reset security code by placing the handset back on the
base for a few seconds. The status LED will blink
indicating that the phone has been reset.
● The Nickel-Cadmium battery pack may be weak.
Charge the battery for 15-20 hours.
● The handset may be too far away from the base.
Place the base away from appliances or metal objects.
● Place the base away from appliances or metal objects.
● Reset security code by placing the handset back on the
charging cradle for a few seconds. The status LED will
blink indicating that the phone has been reset.
SUGGESTION
● Make sure that the base antenna is fully extended in the
vertical position.
● Interference by other electronics equipment such as TVs.
Computers microwaves etc.
● You may have gone too far from the base.
● Press the chan key to search for clearer reception.