Filter
Top Products
16
Australia
If you have the “call waiting” service and a call waiting
tone sounds while you are on a call, press
flash then
2 to accept the waiting call. There is a short pause,
then you will hear the new caller. To return to the
original caller press flash then 1.
New Zealand
If you have the “call waiting” service and a call waiting
tone sounds while you are on a call, press the
flash
button to toggle between the incoming call and the
original call (and visa versa).
After dialling a number you may be requested to enter a special access code, for
example, when performing a banking transaction.
1. Store the access code into one of the memory locations (0-9).
2. Dial the main number.
3. Press
mem and the memory location where you stored the access code at the
appropriate time.
1. Remove the handset from the base.
2. Press
mem twice.
3. Press the memory location number (0-9) you want to clear. You hear a long
beep confirming that you have erased the number.
Remember your XS610 phone has 10 memory locations, represented by the
numbers 0-9 on the keypad. If you store a phone number in one of these
locations, then attempt to store a different number in the same location later, the
new number will replace the previous one.
REPLACING A STORED NUMBER
ERASING A STORED NUMBER
CHAIN DIALLING
flash
flash
USING THE FLASH BUTTON
The flash + 2call waiting
procedure toggles between
the incoming and original
call (and visa versa).
The flash + 1 procedure
will drop the current call
connection and pick up the
incoming call on hold.