Filter
Top Products
INSTAlliNG THE BATTERY
Follow these steps to install the supplied battery into the handset. Then, charge
the battery as described under "Charging the Battery."
1. Use a small Phillips screwdriver
to remove the screw that secures
the battery compartment cover.
Then, remove the cover by
sliding it in the direction of the
arrow.
2. Attach the battery's connector to
the connector inside the battery
compartment. Then, place the
battery inside the compartment.
3. Replace the battery compartment
coverand secure itwith the screw.
The supplied battery should last for
approximately two years. When the
battery cannot fully recharge, you will
need to purchase a new one from
your local Uniden store.
CHARGING THE BATTERY
YOU MUST CHARGE A NEW BAT-
TERY FOR AT LEAST 24 HOURS
BEFORE YOU FIRST USE THE
PHONE.
When you first charge the battery, set
POWERON/OFF to OFF. When you
recharge the battery, you can leave
the power on. Recharge the battery
whenthe BAIT LOWindicator lights.
~
.
~
t
To charge or recharge the battery,
place the handset on the cradle. The
CHARGEindicator will then light.
After you charge the battery, pick up
the handset, set POWERON/OFFto
ON, and place the handset back on
the base. This sets the security ac-
cess protection code, which prevents
others with cordless phones from
using your telephone line.
Notes:
. If the CHARGEindicator does not
stay lit when you place the handset
on the cradle, be sure the battery
and AC adapter are properly con-
nected.
5