Filter
Top Products
BASICS [36]
www.uniden.com
With the base
While using the base speakerphone, press mute on the base to mute the
microphone.
Mute On
and appear in the display. To cancel muting, press mute
again or press speaker.
Mute Off
appears.
Tone Dialing Switch-over
If your telephone company requires pulse dialing, you can
switch-over to tone dialing after the call connects. This
feature is useful when you need tone dialing to use any
automated menu systems, such as telephone bank tellers,
telephone prescription refills, customer support menus,
etc.
If your phone is set to pulse dialing mode, make your call
normally. Once your call connects, press the
*
/tone/<
key. Any digits you enter from then on will be sent as
tone digits. When this particular call ends, the phone
automatically returns to pulse dialing mode.
Traveling Out of Range
During a call, as you begin to move your handset too far from your base unit, noise
may increase. If you pass the range limits of the base unit, you will hear a beep and
see
Out of Range
on the display, and then the handset returns to standby mode.
•The tone feature only
applies when the dial
mode is set to pulse.
•This special number
can be stored in a
memory location. This
is referred to as Chain
Dialing (see page 41).
note
BASICS