Filter
Top Products
8
Troubleshooting
If your cordless telephone is not performing to your expectations, please try these simple
steps.
NOTE: Do not attempt to service this unit yourself. Servicing must be performed by
qualified personnel.
Symptom
The charge/in use LED won’t
illuminate when the handset
is placed in the base.
The audio sounds weak
and/or scratchy.
Can’t make or receive calls.
Handset doesn’t ring or
receive a page.
Severe noise interference
If you still have a problem
Suggestion
• Make sure the AC adapter is plugged into the base and a wall outlet.
• Make sure the handset is properly seated in the base.
• Make sure that the charging contacts on the handset and on the
base are clean.
• Move the handset and/or base to a different location away from
metal objects or appliances and try again.
• Press channel to help eliminate background noise.
• Check both ends of the telephone line cord.
• Make sure the AC adapter is plugged into the base and a wall outlet.
• Make sure that the base antenna is in the vertical position.
• Disconnect the AC adapter for a few minutes, then reconnect it.
• Change the digital security code (See page 7).
• Make sure that the handset is not too far from the base.
• The Nickel-Cadmium battery pack may be weak. Charge the
battery for 15-20 hours.
• The handset may be too far away from the base.
• Place the base away from appliances or metal objects.
• Change the digital security code (See page 7).
• Keep the handset away from microwave ovens, computers, remote
control toys, wireless microphones, alarm systems, intercoms,
room monitors, fluorescent lights, and electrical appliances.
• Move to another location or turn off the source of interference.
• Call our customer hotline at 1-800-297-1023
Liquid Damage
Moisture and liquid can damage your cordless phone. In case of accidental submersion,
please read the following steps.
Case
If the handset or base is exposed
to moisture or liquid, but only
affects the exterior plastic housing.
If moisture or liquid has entered
the plastic-housing (i.e. liquid can
be heard in the phone or liquid
has entered the handset battery
compartment or vent openings
on the base).
Action
Wipe off the liquid and use as normal.
Handset:
1.Remove the battery cover and leave it off for ventilation.
2.Remove the battery pack by disconnecting.
3.Leave the battery cover off and the battery pack disconnected for at
least 3 days.
4.Once completely dry, reconnect the battery pack and the battery cover.
5.Recharge the handset’s battery pack for 20 hours in the base unit
before using the phone.
Base:
1.Disconnect the AC adapter from the base unit, cutting off electrical
power.
2.Disconnect the telephone cord from the base unit.
3.Let dry for at least 3 days.
IMPORTANT: You must unplug the telephone line while
recharging the battery pack to avoid charge interruption.
CAUTION:
DO NOT use a microwave oven to speed up the drying process. This will
cause permanent damage to the handset, base and the microwave oven.
After following these steps, if your cordless telephone does not work,
please send to:
Uniden America Corporation
Parts and Service Division
4700 Amon Carter Blvd.
Ft. Worth, TX 76155
1-800-554-3988. Monday through Friday
8 a.m. to 5 p.m. CST
EXP3240_UP001BH UP001BA_1 1/7/3 5:29 PM Page 8