Filter
Top Products
3
5) Place the handset in the base with the keypad facing
forward. Be sure there is sufficient space to raise the base
antenna to a vertical position.
NOTE: • Use only the Uniden Battery (BT-905) supplied
with your phone. Replacement batteries are also
available through the Uniden Parts Department at
(800) 554-3988, Monday thru Friday from 7:00 a.m.
to 5:00 p.m. or online at www.uniden.com
Battery use time (per charge)
From fully charged
• Up to seven hours continuous use
• Up to fourteen days when the handset is in the standby mode
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed to
eliminate functions in order to save power. If the phone is not in use, the talk/batt low LED
flashes when the battery pack is low.
If the phone is in use, the talk/batt low LED flashes and the handset beeps. Complete your
conversation as quickly as possible and return the handset to the base for charging.
Cleaning the battery charging contacts
To maintain a good charge, it is important to clean the charging
contacts on both the handset and base unit once a month.
Use a dry cloth or a pencil eraser to clean. If the contacts
become very dirty, using water only, dampen a cloth to clean
the charging contacts. Then make sure to go back over the
charging contacts with a dry cloth before returning the handset
to the base to charge.
NOTE: Even when the battery pack is not being used, it will gradually discharge over a
long period of time. For optimum performance, be sure to return the handset to the
base unit after each telephone call.
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack
and a standard 120V AC wall outlet.
2) Wrap the cord inside the molded wiring channel
as shown.
3) Set the base unit on a desk or tabletop, and
place the handset in the base unit.
4) Make sure the charge/in use LED illuminates.
If the LED does not illuminate, check to see that
the AC adapter is plugged in and the handset
makes good contact with the base charging
contacts.
NOTICE: Place the power cord so it does not create a trip hazard or where it could
become chafed and create a fire or electrical hazard.
NOTE: • Use only the supplied AD-446 AC adapter. Do not use any other AC
adapter.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC adapter
easily.
After installing the battery pack in the handset, charge your handset at least 15-20
hours before plugging into the phone line. Once the handset battery pack is fully
charged, connect the telephone line cord to the base and telephone wall outlet.
Route the cord.
EXP3240_UP001BH UP001BA_1 1/7/3 5:29 PM Page 3