Filter
Top Products
Making and Receiving Calls
NOTE: •The redial/p key redials the last number dialed.
• The redialed number can be up to 24 digits long.
5) Connect the telephone line cord to the TEL LINE
jack and a telephone outlet once the handset is
fully charged.
TIP: If your telephone outlet isn’t
modular, contact your telephone
company for assistance.
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
1) Press and hold flash until you hear a confirmation tone.
2) To set the dial mode for pulse dialing, press #. Or to set the dial mode for tone dialing,
press
*
/tone. A confirmation tone sounds to indicate the setting is complete.
• If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call
connects, leave the setting as is, otherwise set for pulse dialing.
• If your phone dialing system requires pulse dialing and you need to send DTMF tones
for certain situations during a call, you may “switch-over” to tone dialing (Refer to “Tone
Dialing Switch-over”).
NOTE: Make sure your battery pack is fully charged before choosing the dial mode.
4
Handset On Base
Answer call
When the phone rings, remove
the handset from the base
(AutoTalk).
1) Remove the handset from
the base and press talk.
Make call 2) The talk/batt low LED
flashes and turns on.
3) Listen for the dial tone.
4) Dial the number.
Hang up Press end or return the handset to the base (AutoStandby).
1) Remove the handset from
the base and press talk.
Redial 2) Listen for the dial tone.
3) Press redial/p to dial the last
dialed number.
Ringer Mute None
Modular
Using Your Phone
Handset Off Base
Press talk, any number key,
*
/tone,
or # (AutoTalk).
1) Press talk.
2) The talk/batt low LED flashes
and turns on.
3) Listen for the dial tone.
4) Dial the number.
1) Press talk.
2) Listen for the dial tone.
3)
Press
redial/p
to dial the last dialed
num
ber.
Press end
when ringing.
EXP3240_UP001BH UP001BA_1 1/7/3 5:29 PM Page 4