Filter
Top Products
EXPANDING YOUR
PHONE
[ 47 ]
Register the Handset
If you purchase an extra handset, you need to register the handset before use.
Only one handset can be registered at a time.
The handset ID for the supplied handset(s) was assigned at the factory, which has
#1 (#1 and #2 for DCT5260-2) in the display. When you register additional handset
to the base, the handset ID will be assigned.
An extra handset can be registered when the base is in the standby mode.
While charging the batteries, all the handset keys will be disabled.
1) After charging the handset, remove the handset from the charger and place it in
the base.
2) Registration starts automatically.
While registering, “Handset Registering” appears in the display.
3) When the registration is complete, “Registration Complete” appears in
the display.
If the registration fails, “Registration Failed” appears in the display. Try the
steps above again.
3) Install the new batteries supplied with your phone. Check for correct polarity
(see page 13).
“Please Register” appears in the display.
4) Replace the battery cover by sliding it upward.
5) Place the handset in the charging cradle, and allow it to charge for 17-20 hours.
EXPANDING YOUR PHONE
DCT5260-2_UP301BH UP01301BZ_1 1/16/03 10:04 AM Page 47