8
TO OPERATE IN DUPLEX MODE (REPEATERS)
The Duplex function enables you to access local repeater
stations. You can only activate Duplex from CH01-CH08.
UHF CB Repeaters are used to retransmit or relay your signal.
Repeaters will extend the range of your radio and overcome the
shielding effect caused by solid obstructions.
SCANNING
The scan function scans all channels and stops at an active
channel. When the signal stops, the UH060SX-2 waits 2 seconds
(Reply Delay) before scanning resumes.
Press
dup/call
key momentarily. The
changes to .
Press
dup/call
key again to deactivate the
duplex operation. UH060SX-2 will return to
normal operation.
Operation with the aid of a Repeater
Contact your retailer for a list of repeaters
available in your area.
If
dup/call
key is pressed when the channel is not
from CH01 - CH08, an error tone sounds.
UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 8