Uniden UH060SX-2 Two-Way Radio User Manual


 
4
Place the UH060SX-2 into the charge cradle. The charge light will
come on to indicate the unit is charging. Before operating the
UH060SX-2, charge the battery pack for 16 hours.
If the battery level becomes low, the battery
indicator icon on the display begins flashing.
When the batteries in the unit are low, the unit will go into a
Battery Low mode. The Transmit mode is disabled. Replace the
alkaline batteries immediately or if you are using the NiMH
battery pack, place the radio on the charge cradle to recharge.
Full charge will take up to 16 Hrs.
Do not charge alkaline or non
rechargeable batteries.
BELT CLIP
LOW BATTERY ALERT
To attach the belt clip:
Slide the belt clip until it snaps into place.
To remove the belt clip:
To remove the belt clip, press and hold belt
clip locker, slide the belt clip at the same
time until released.
INSTALLING THE CHARGE CRADLE
Plug the AC adaptor into the rear of the charge cradle and
into the mains power.
UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 4